Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Like a Tormek?

Posts

Like a Tormek?

#1

Like a Tormek?

Stuart Hough

>Does anyone have any info on the Scheppach TiGer sharpeners? Are they good quality? Do they even approach the Tormek? Woodcraft has them for low money, but I need some info before I pop for it. Thanx in advance for any info.

Re: Like a Tormek?

#2

No, but

Bill Houghton, Sebastopol, CA

>I wonder how they compare with Delta's wet wheel grinder, too?

My only real complaint about the Delta is that grinding is slooooow.

Re: Like a Tormek?

#3

Re: Like a Tormek?

Howard Norman-Prescott, AZ

>I bought the Grizzly wet grinder a couple of weeks ago. It is made in Germany according to a sticker on the unit. So far it seems OK. Certainly a lot cheaper than a Tormek. I haven't used it enough to evaluate it carefully yet.

Re: Like a Tormek?

#4

Re: Like a Tormek?

Bill Hylton

>I had the opportunity last year to try out four wet grinders for an article in Woodworker's Journal. I have no doubt that the Tormek is tops. But it's expensive.

Two Scheppach-made wet grinders are sold in the USA. The TiGer, marketed by Rikon, is the smaller machine. Don't have the data in front of me, but I think it's an 8" or 9" stone vs. 10" or 11" used by Tormek. The second Scheppach-made grinder is the Grizzly. Its stone is the same size as Tormek's. Dramatically less costly than the Tormek. Seemed to me that the Scheppach-made grinders are as gutsy as the Tormek; couldn't stall any of them. But the tool-holding jigs sold with/for the Grizzly/Scheppach machines are crappy and imprecise.

However. I found that the Tormek tool-holders fit the Grizzly/Scheppach grinders, and using them with the latter grinders eliminated problems I experienced in setup and grind accuracy. Were I to buy a wet grinder, I'd get the Grizzly. But I'd buy and use the Tormek toolholders.

Bill

PS: the fourth wet grinder I tried was the Jet, which I really wanted to like, but just couldn't. Too easy to stall. And the tool-holders, though spiffy looking, weren't as accurate as the Tormek's.

PPS: I also tried some dry grinders--Work Sharp, Veritas, Lap Sharp. Liked those better. No water.

Re: Like a Tormek?

#5

Re: Like a Tormek? *LINK*

Marv....... Northern California Lake Co.

>Hi Stuart,

Seems to me that Leif Hanson has one. If you hop on over to his website, you can blog him. He always has lots of information and sources on just about anything.

Marv


Leif Hanson's website

Re: Like a Tormek?

#6

Thanx for the responses!

Stuart Hough

>