Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Speaker Cabinets

Posts

Speaker Cabinets

#1

Speaker Cabinets

howard

>I'm building speaker boxes to cover a clients wall mounted speakers. Anyone know where to get the snap on hardware for the cover, I'm familiar with the plastic ones that come on many speakers, but don't know where to get them. Thanks for any leads.

Re: Speaker Cabinets

#2

Another approach

Grant in Iowa

>Howard,

While I can't tell you where to get the cup and ball speaker grille catches, I can tell you about what I have done.

I have used rare earth magnets in cups to hold speaker grilles in place with great results. Since there are magnets on all four sides, they actually hold the grille in a "force field" so they actually hover in place. While the pictured ones are were flush mounted within a frame, you could use them to surface mount a grille on an enclosure. Maybe add some rubber bumpers on each corner of the grille for rattle resistance.

And while we are on the subject, I have figured out a way to secure the grille cloth seamlessly. I cut a 1/8" saw kerf about 1/2" from the inside edge and on the back of the frame stock before I assemble the frame. Once the frame is assembled, and similar to how you install window screen with a noodle, I use 18AWG stranded (automotive type) electrical wire as a classy looking noodle to install the grille cloth just like a screen. Trim the excess cloth with a sharp knife for a nice look and secure fit. This approach actually results in a recessed cloth look, or you could stretch the cloth over the front of a rounded over frame and use the same attachment technique for a classic speaker grille look.

In the attached photo, note the cloth is flush with the outer frame. This look is done by using an inner frame within the visible outer frame. The saw kerf and wire are hidden between the inner and outer frame.

Clear as mud?

Regards,

Grant in Iowa


img

Re: Speaker Cabinets

#3

Re: Speaker Cabinets *LINK*

John McGaw

>Well, some folks use small patches of industrial-strength Velcro to attach grilles. Personally, I find that the adhesive fails on the patches in pretty short order if the grilles are removed and replaced repeatedly. Another option is to use small neodymium magnets. But if you want the "real thing" check out Parts Express. Part numbers 260-368 with 12 pairs per package or 260-366 with 8 pairs per package are the old-school way of doing the job.

If you are going to be doing any sort of audio work, the Parts Express catalog is a must-have.


Parts Express Site

Re: Speaker Cabinets

#4

Re: Speaker Cabinets

Bill Earl

>Parts Express is a good source, as is Madisound. If I were building another set, I'd go with the magnets.

Re: Speaker Cabinets

#5

Re: Speaker Cabinets

howard

>Thanks for the contacts - I did call parts Express and placed an order. Thanks again this was really great!

Re: Speaker Cabinets

#6

I've had success w/velcro

Dan Mitchell

>by attaching the material with contact cement, rather than relying on the adhesive "tape" that comes on the backs of the velcro sections. Haven't had one pull off yet.

Dan

Re: Speaker Cabinets

#7

Re: I've had success w/velcro - me too

Bob Entwisle in NJ

>I've used the 3M? (I think is the manufacturer), If you read the literature, the adhesive of the peal and stick stuff needs to be allowed to set up and dry, just like any other glue.

Good clean surface, stick it on, and leave it alone for 24 hours or more and you should have no issues with the adhesive failing.