Re: I named it a 'BigFoot' in my book
Carol - now back in Dubuque, IA
>Some thoughts from the originator:
I tried the cord hook, and found it cumbersome. There were too many times I wanted the cord elsewhere. When the cord and the handle needed to be in close proximity, I simply included it in my grip of the handle. If a time comes where you want the cord 'fixed' in that place, temporarily simply thread it through the hand hole.
With regard to fitting collars into it, here is what I did.
Remember the concept of center. Mark center the best you can on the Plexiglass (acrylic). (BTW, don't use Lexan or polycarbonate. It bends!) Drill a 1/4" hole at that point. Then insert a 1/4" straight bit in the collet on the router. Drop the bit into the drilled hole. Do NOT turn the router on or even have it plugged in.
Now mark the screw mounting holes using transfer punches (around $10 from HF for a whole set). Set aside the router. Drill the appropriate sized holes for mounting your router. Do NOT countersink them just yet! Remove the plastic base plate on your router (usually black). Using some longer screws, screw the router base plate to the D-handle plate. Carefully drill a larger hole. I use a spade bit in the drill press with the assembly clamped to the drill press table. Don't try to match sizes, just bigger that your flush trim bit diameter.
I use a router table with the flush trim bit. Drop the screwed together assembly over the flush trim bit and router out a perfected sized, perfectly centered hole. Now disassemble the plates.
Install a rabbet bit in the router that meets or slightly exceeds in overhang, the rabbet in the router's original base plate. Route to the same depth as the original.
NOW countersink the router base mounting holes, paying strict attention to which side of the plate is against the router. Or you will be starting over. :-)
Install your handle on the D-plate. Use your factory collars with impunity.
See more in the book. Router Joinery Workshop. By yours truly.