Re: I wouldn't hang it from the joists
Ed Mulligan, Cape Cod
>This isn�t pretty but it�s cheap, quick to make and works well.
The uprights are a sandwich of three 2x4 wall studs glued and screwed together. Before assembly the central stud is cut to form 3 or 4 mortises to receive 2x4 shelf support arms. The mortise upper and lower faces are cut at a 3 or 4 degree angle so the shelf supports have a slight up-angle. Shelf supports are 18� long with 14 �� exposed.
Position the uprights on the concrete floor and bolt them to the floor joists. The uprights don�t have to contact the wall. The concrete floor will probably not be level and so the shelf supports will slightly out of alignment horizontally. To correct this on my shelf I just tacked shims on the low supports.
My shelves have uprights every second joist or 32�. Four uprights span 8� and can accept 10� lengths of lumber. Each shelf support can support many hundreds of pounds of weight. Each 8� shelf with 3 supports can support 1,000 pounds plus. If there are 4 shelves on a set of 4 uprights they can hold several tons.
