my experience
Bill Tindall, E.TN
>I consider the tool rests the best commercially available. They are big(very important) and tools slide on them easily. And the are not wobbly like the LV rest.
I find the wheel dresser useful for truing the roundness of wheels. Hand held dressers can fail to make an out-of-round wheel round. Out of round wheels vibrate the grinder in an annoying way.
The attachment for doing spindle gouges and the one for roughing gouges I find very helpful, in fact essential, for my lack of gouge grinding skills. They work reliably.
The attachment for chisels and plane irons in not necessary. If that is what you are talking about don't buy it as you will in short time not use it. To grind these tools you need to crown the wheel, and using the wonderful large tool rest, free hand grind these edges. Now, you don't do this by plunging the tool straight into the wheel. Rather, you sweep the tool across the crowned wheel left to right and right to left. The crown enables the center of the edge to be ground while not rounding over the corners. Using this very light "touch and go" back and forth motion you slowly grind the edge, checking with a square to see that you are keeping it straight. A few free hand strokes on a flat stone (I use diamond) will reveal if the edge is straight. If not, the crowned wheel will enable the high spots to be preferentially removed. Sounds difficult, but a bit of practice on a junk plane iron will teach you the technique.