Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Jointing plywood?

Posts

Jointing plywood?

#1

Jointing plywood?

Terry Alexander

>Sometimes a dado for a plywood is just too much of a hassle and not really necessary. However, I would like a clean, 90 Degree, straight edge on my 3/4" plywood.

Are there any "rules" for jointing plywood?

Will it harm my jointer?

Reason I ask is that I don't believe I have ever seen Norm joint plywood and I have seen (I think) all of his programs.

As always...TIA

Terry Alexander in West Texas

Re: Jointing plywood?

#2

Not A Great Idea

Mark Mandell - Gone Round In Jersey

>2 reasons.

a. Your edge is usually 50% end grain which will tear out badly.

b. The laminating glue is abrasive and will dull HS steel knives rather quickly.

If I had a carbide Shellix head, I "might" try it. Otherwise, put a bit of time into tuning your table saw to a dead nuts 90� cut and go for it.

Re: Jointing plywood?

#3

Alternative

Mark Mandell - Gone Round In Jersey

>You can also set up a router and a guide fence and get a good cut with a good sharp 1/2" or bigger carbide bit. Just take smaller bites, like 3/16" max, at a pass.

HTH

m

Re: Jointing plywood?

#4

edge band?

paul in AZ

>with either the iron-on tape or my preferred route of a 1/4 inch or less strip of wood matching the face wood.

Re: Jointing plywood?

#5

I do it

Clint Searl, at the base of Haycock Mtn

>I do it, especially when working with Baltic birch, with no apparently worse wear on the jointer than yellow pine. Best way to get a clean, smooth, square edge. No tearout, either.

Clint

Re: Jointing plywood?

#6

Re: Jointing plywood?

mamc

>I've done it as needed. Taken small amounts just to clean up and edge or dial into a certain width. No problems or tearout.

Got a kick out of your Norm comment.

Thankfully I've never seen Norm shower either, but I bet he does it!

Try it I doubt you'll damage anything.

Good luck

Re: Jointing plywood?

#7

Re: I do it

Fred Davis

>I agree with

Clint jointing plycore IF it is all wood and not a sandwich of Particle board or masonite which will dull you jointer knives quickly.

FredD