Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

What to use for a cross end?

Posts

What to use for a cross end?

#1

JL

What to use for a cross end?

JL

>I want to make some wooden crosses. Sort of like for a large rosary or similar. What to use for an end to suspend the cross though?

A zinc plated "eye" would look sort of tacky. Brass would be better, but I don't know. Antique brass would probably be better than bright brass. I don't know if a hole bored through would work - though it would be the easiest.

Any thoughts? TIA.

Re: What to use for a cross end?

#2

Key Hole

Dustmaker Mike

>I think I would use a keyhole in the back to hang the cross. If you hang it off a chain than this idea would not work, but there are loops that can be hidden on the back of the upright piece.

Re: What to use for a cross end?

#3

How large?

Ellis Walentine, Host

>

Re: What to use for a cross end?

#4

JL

Re: How large?

JL

>I was going to make the thickness about 1/2". I was thinking about maybe 2-3" high.

Re: What to use for a cross end?

#5

Re: What to use for a cross end?

Barry Irby

>You could use a router bit that makes a keyhole slot. the bit is basically a tiny wing cutter. You plunge in (or drill a hole) and route up toward the top. The slot is flared open on the inside so that the Cross could be hung form a screw or nail head.

But, why don't you just drill a hole at an angle so that you could just drive a nail in the wall and the hole would match the angle of the nail. Sort of like french cleats on a single point basis.

Re: What to use for a cross end?

#6

Re: What to use for a cross end?

Mark Mandell - Gone Round In Jersey

>Suggest you drill a slant hole from the center of the top end into the back surface, then make a jump ring to take or tie to the rosary chain.

You can also do a disguised loop by doing a wrap of the top branch in say 16ga silver wire to look like rope, then pull a loop in that and epoxy both ends back into your wood.

Re: What to use for a cross end?

#7

How about...

John in NM

>A hole with a brass sleeve through it (like K&S tubing from the local hardware or hobby store). You could also make a bail out of brass wire, bend the loose ends at 90 and stick them in a small hole on the back side of the cross, maybe 1/4" or 1/2" down from the top. Then wrap more (and maybe thinner) brass wire around the hole and the bail. I did that to a mallet I made once (wrapped the handle just below the head, no bail on the mallet), both for looks and a little added re-inforcement - though I don't know as it needs the latter.

Re: What to use for a cross end?

#8

JL

Thanks - I can get some silver wire.

JL

>

Re: What to use for a cross end?

#9

JL

Thanks - if I can't get the wire, I may try it.

JL

>