Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Bending wood - steaming vs. bathtub

Posts

Bending wood - steaming vs. bathtub

#1

Bending wood - steaming vs. bathtub

Steve Silca

>Good morning,

I have built a full kitchen in my basement and made some nice laminate countertops. Rather than putting laminate on the edges of the countertop (which screams, "I am a fake laminate countertop"), I have purchased some nice maple trim to wrap the edges. This will be straightforward except on the peninsula I have a slightly curved end.

This is a very slight curve - maybe a difference of 3" from the edge of the counter to the tip of the curve. If I were to guess I would say the curve would create about a 12' diameter circle - it's pretty slight. But, the maple is still too rigid to make the bend. So, should I go through the trouble to create a steaming set-up to soften the one piece, or can I just soak it for a while in a bathtub and work with it from there? Your thoughts are appreciated

Re: Bending wood - steaming vs. bathtub

#2

Re: Bending wood - steaming vs. bathtub

Barry Irby

>First, if you are working with wood that was kiln dried, it is much less likely that either steaming or soaking will work. The lignum in the wood is "set" by the heat of the kiln and will resist the effects of the steam or warm water.

Rather than building a steam box, If you have some wood to spare, I would try soaking a piece in the bath tub and see if that works. The only cost would be the piece of wood. My understanding is that its really the heat that softens the wood, not actually the water or the steam. So, since you don't have a really good way to keep the water in the tub really hot long enough, it does not bode well.

I think I would use a bent wood lamination. Rip strips that are wide enough and 1/8 to 3/16" thick and bend them and glue them. you would need a form that exactly matches your counter top or figure a way to clamp them directly in place. If you use yellow or white glue and are careful matching the grain it could be nearly invisible.

Re: Bending wood - steaming vs. bathtub

#3

Ditto to Barry, but

Mark Mandell - Gone Round In Jersey

>Mere water won't help much, but you can still try to steam or boil a piece. Cut/build a clampijg caul to match the curve + the trim thickness. Apply, clamp, and let for a few weeks. You'll get some spring-back, but the amount may be slight enough that your glue will still hold. If your trim is thick enough, you can also toe nail or slant dowel the two ends for some extra hold.

Next time, however, try this.

It's always an issue with applying the trim to the pre-laminated top as it's nearly impossible to keep the wood dead even with the laminate. The wood than takes a beating as the counter is used. You can avoid all this if you apply your trim BEFORE applying the laminate. Apply and carefully belt sand the trim so it's flush with the substrate's top (and bottom) surface(s). You then apply laminate right over the trim. Trim off the excess laminate flush. Now change bits and come back with a champfer bit of your choice and cut the top edge back less than the wood trim thickness (I use 1/2-3/4" trim stock and cut back 1/4 - 3/8" on a 45�). You get a beautifully finished edge profile that will still protect the edge of your laminate from dings and chips, but you also get a wood surface that can carry a finish and won't get beat up during use of the counter.

Using this method, you can segment your trim around any curve (depends on the cut angles) and then smooth the outside curve with a belt sander or trim with a pattern and bearing router bit. The laminate then covers the "inside" structure of the segments.

mm