I made a steering wheel
Tom Sontag - St. Louis
>A friend of mine bought a 1965 Austin-Healey 3000. Suddenly I began to think that here was a fellow I always appreciated, but perhaps not as much as I should have. When I commented that the after-market steering wheel did not match the figured walnut dash, he handed me the original wheel covered in cracked Bakelite. He knows I do not take commissions, but that I sometimes do favors. The challenge was too much to resist. Besides, I'd get to test drive the result.
I had a piece of crotch walnut I bought years ago from a toothless guy. This was the project it was waiting for. I roughed out some segments and removed the Bakelite from the original.

I glued the segments to the laminated walnut shown above and routed the approximate shape using a plywood template. I made the template using a trim router with a custom bottom and a nail for the pivot point.

I routed the groove for the wire on the router table.
I then carved out the bits for where the spokes enter the rim and tested the fit.

Hey, this might turn out. Too big though, so I rounded it over and ended up removing considerable thickness from the inside, primarily by rasp.

I cut the finger grips with a half round file and put a coat of walnut dye (made from walnut husks, see toolsforworkingwood.com).

Some work painting the hub and a few coats of a UV varnish and it was ready to install.
BEFORE:

AFTER, including new shift knob:


Oh, you'll want to see the exterior too. This is actually a different car, but his looks just like it. Yes, it is fun to drive!





