Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Dispoz- a-blade

Posts

Dispoz- a-blade

#1

Dispoz- a-blade

David in Indy

>I recently replaced the knives in my Delta 15" planer with the "self set" dispoz-a-blade system from ESTA-USA. Shortly after the change, one of the knives moved up out of position during operation, causing, as you might expect, what looked like the largest snipe ever. I reinstalled the blades, making sure to tighten all of the screws that hold the blades in position. It worked fine for a couple of weeks until the same problem occurred yesterday, completely destroying a panel I had worked some time on.

Before I call the manufacturer or dig out the jack screws I removed and go back to the old blade system, I wanted to see if anyone else had encountered a similar problem or had any more specific suggestions to address the problem. Thanks.

Re: Dispoz- a-blade

#2

Re: Dispoz- a-blade *LINK*

Thomas Skaggs, Foothills of Mount Level

>I think experience with that system varies. I have heard good and bad. For me, it was bad. I did not have quite the same problem but never got the performance desired.

If you decide to go back to standard knives I highly recommend a set of high tungsten steel knives from Sharpco. Best results I ever got with standard knives.

Tom


Sharpco

Re: Dispoz- a-blade

#3

Jim DeLaney, Austintown, Ohio

Re: Dispoz- a-blade

Jim DeLaney, Austintown, Ohio

>I've had them in both my 6" jointer, and my 15 inch planer for something over two years, and they've performed perfectly.

Any chance you gib screws are backing off? What about oil, or wood dust behind the blades?

Jim D.

Re: Dispoz- a-blade

#4

Re: Dispoz- a-blade

David Sparks

>I've had a set of Esta cobalt blades in my planer/jointer for years and have never had a problem. I'd call Esta and see what they say. Using sandpaper to rough up the contact surface of the screws holding the blades might help.