Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

finishing (or not) dry through tenons

Posts

finishing (or not) dry through tenons

#1

finishing (or not) dry through tenons

Phil in NJ

>Hi,

Just finishing a Stickley even arm knock-down settle (#210). This design has the sides of the settle fully glued, however the two sides are connected by 3 long boards with long through tenons, which are held in place with removable pegs.

Picture is attached.

My question is whether I should finish these tenons and insides of the mortises? I would like to finish them with perhaps a single coat of shellac, but am fearful that they might then stick later?

Thanks,

Phil


img

Re: finishing (or not) dry through tenons

#2

Re: finishing (or not) dry through tenons

Frank Mutchler

>How about using BLO or WATCO, etc?

Re: finishing (or not) dry through tenons

#3

Re: finishing (or not) dry through tenons

Ed Mulligan, Cape Cod

>Nice looking piece.

I can't think of any advantage to putting shellac on the interior mortise and tenon surfaces but since you want to do it I can't think of any harm either other than time to do it. A coat of shellac isn't going to be a sticky problem.

Re: finishing (or not) dry through tenons

#4

Re: finishing (or not) dry through tenons

Gary Evans Tallassee, TN

>Hey Phil,

I wouldn't hesitate to put a coat of shellac on the tenons. I would wax them afterward to make sure they don't stick when it comes time to knock the thing back down. The wax could be reapplied before reassembly.

Gary