Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Deacon #2

Posts

Deacon #2

#1

Deacon #2

Lee Schierer - McKean, PA

>Here is the second Deacons bench I've made. This one was a commission job and will get delivered Sunday. A lady from church saw the one I made for the church and asked if I could make her one that was slightly shorter in the back than the original. This one is made from red oak, stained golden oak and finished with Cabot Clear semi gloss brushable lacquer. Making the second one was easier than making the first as I had already figured out how to make the various pieces.


img

Re: Deacon #2

#2

Re: Deacon #2

Jim Shaver - Oakville, Ont

>Hi Lee,

It is wonderful! I have long wanted to make one myself, you have really done a great job on this one!

Congrats!

Take care,

JIm

Re: Deacon #2

#3

Re: Deacon #2

Stuart Hough

>Gorgeous piece, Lee!

Re: Deacon #2

#4

Re: Deacon #2

George@Colonel's Workshop-Havertown PA

>Good Afternoon Lee,

I really like the bench, especially the raised panels. Did you do them on the table saw or with the router? And, how long is the front panel? I can see why you like lacquer so much. The finish is nice, for sure.

George

Re: Deacon #2

#5

Re: Deacon #2

Dick Haley

>Lee,

What a beautiful piece...really like the design.

Re: Deacon #2

#6

Answers *LINK*

Lee Schierer - McKean, PA

>George, the base is 44" long and the back on this one is 36" high. The raised panels were made with a router and TS, following the procedure I have on my website, see the link. The front, rear and side pieces are all set into the legs with M&T joints. The vertical panels on the front rear and sides are also M&T joints to the rails.

Jim, I have a dimensioned drawing if you need one to get you started.

Lee


Raised panels on a TS

Re: Deacon #2

#7

Thanks Lee

George@Colonel's Workshop-Havertown PA

>

Re: Deacon #2

#8

Re: Deacon #2

Fred Davis

>Lee,

I think I have said here before I like making Benches and yours is one I would like to say I made . ;-))

FredD