Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Reading Your Boards- bugs in the wood

Posts

Reading Your Boards- bugs in the wood

#1

Reading Your Boards- bugs in the wood

Bill Tindall, E.TN

>Reading Your Boards- bugs in the wood

Shown in the picture are two exposed sawed edges from an 8/4 white oak plank. Only upon very careful scrutiny would one see the occasional 1/16� entry or exit hole in this plank�s surface. However, you can see that the inside is riddled with tunnels from powder post beetles. The edge closest is worst because this portion of the board contained some sapwood which is the preferred diet of this pest. What is unusual is that these critters even penetrated into the heartwood. Obviously, this plank is ruined.

Many years ago it was common to dip commercial lumber is a highly toxic chemical closely related to pentachlorophenol- wood preservative. This stuff killed mold to prevent staining and killed bugs too. It has been banned so this protection will not be found on modern lumber.

Because the entry and exit holes are so small and few any evidence of fresh sawdust on a stored board is cause for alarm for major damage may be occurring within. Kiln drying will kill these insects but kiln drying will not prevent their invasion in the dried lumber. I think they prefer air dried lumber but I can�t be certain of this observation. I know they prefer ash and they seem to like oak and to a lesser extent walnut sapwood. For some reason I have never had an invasion in poplar but a friend had several hundred feet of 8/4 poplar ruined.

Experience like this led me to treat all my stored lumber with insecticide. Anything good for termite prevention should be effective for preventing an invasion of these bugs. I have not had a problem since my treatment program was instituted years ago.


img

Re: Reading Your Boards- bugs in the wood

#2

JL

I had some green oak lumber with larger holes.

JL

>The holes were ~1/4" in diameter. There was an off-white grub at the bottom of the hole. The larger grubs were maybe ~3/4-1" long.

Any idea what the grub was? I don't think it was a powderpost beetle.

Re: Reading Your Boards- bugs in the wood

#3

Re: Reading Your Boards- bugs in the wood

chuckbeck in cent il

>If I remember correctly the powder post beetles tend to go for whatever type of sugars are in the sapwood. When the wood is kilned up to a certain temperature it changes the structure of the sugar so that it is no longer viable food and they long elsewhere. Obviously my details are a bit sketchy, but KD lumber can still be munched if it does not get hot enough for long enough to cause a chemical change in the sap. If I remembered where that info came from I'd get it, but instead they're just brain droppings.

chuckbeck

Re: Reading Your Boards- bugs in the wood

#4

which insecticide?

Phil Joines in Krum, Tx

>I use a good bit of mesquite and it almost always has bugs.

Re: Reading Your Boards- bugs in the wood

#5

Dale Lenz

Re: I had some green oak lumber with larger holes.

Dale Lenz

>JL: I refer to those grubs as bark beetle larvae. Often find them under the bark of firewood/lumber with bark. Once the wood dries, the critter will be gone. Often thought the grubs should make good fishing bait, let us know, : ' >.