Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

finishing

Posts

finishing

#1

finishing

DP

>I just completed dry fitting and sanding (from 80 grit to 220 grit) my Arts and Craft bed. The bed is constructed out of white oak. Would preping the wood with a shellac and denatured alcohol mix be the correct thing to do before staining? I've done this with pine many years ago, but didn't know if woodworkers do this with oak also.

Thanks for all your opinions on this and other question that I've posted in the past. I might add that I'm going to the Woodworking Show in St. Louis this weekend and hopefully meet Norm.

Thanks

Danny

Re: finishing

#2

Re: finishing

Fred Davis

>If the White Oak didn't have any bark on it , why would you start sanding with 80 grit??

FredD

Re: finishing

#3

Re: finishing

Steve Schoene

>No you shouldn't need to pre-seal white oak. Oak doesn't "blotch" like pine or maple. It doesn't even "bleed back" oil based stain from it's pores to the extent that red oak can do, though with any open pored woods it's a good idea to stain (or apply an oil finsih) early enough so you can check it in a half hour to see if there has been any bleeding.

You can get a good feel for this when you to your sample board, from stain to top coat. Finishing scrap is an essential step when ever using a finishing schedule new to you.

Re: finishing

#4

Practice, and not on the finished piece

Bill Tindall, E.TN

>Finishing questions are common on this forum. Because of the complexity of finishing-techniques and materials- as well as individual tastes, it is difficult to offer sufficiently detailed and insightful advice that will ensure someone's finishing success.

Therefore.........always practice a finish on a test pieces before proceeding to the final object even if the new finish seems to be but a minor modification of something you have used before. Somewhere in the course of the project I will select a test piece of the wood and carry it through the surface preparation steps and then apply my proposed finish to it. I was driven to this approach after screwing up a lot of hard work on the occasions early in my woodworking career when I didn't follow this advice.

To deal with your specific question, I usually don't sand oak that fine if I am going to stain it. But if you want the pores dark and the rest light, then you might consider sanding fine and doing a wash coat of shellac. The look will be very different and who knows what you might prefer.