Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Knife hinge fear - overcome!

Posts

Knife hinge fear - overcome!

#1

Knife hinge fear - overcome!

Dan Collins

>Friends: A couple of weeks ago, I posted a message about my reluctance to install knife hinges on a lingerie closet I was building for my wife. The hinges were just about the last part of the project and I didn't want to screw it up after all the time that went into it. With your advice and encouragement, I did go ahead and use the knife hinges. It worked great. The whole piece is hardwood cherry with birch panels in the doors. If I could figure out a way to get my jpeg pictures down to the required 80kb for posting on this site, I would post a couple of pictures. I can't find a way for my adobe photoshop starter edition software to get the photo files that small (even cropping the pictures only got them down to 125kb). Anyway, my wife loves the closet and that is all that counts in my book. Thanks again for all your help. Dan

Re: Knife hinge fear - overcome!

#2

Re: Knife hinge fear - overcome! *LINK*

mdclor

>Try this free software.

HTH,

Merle


Shrink Pic

Re: Knife hinge fear - overcome!

#3

One Photo

Dan Collins

>I was able to reduce the photos, so I'll post 3. Dan


img

Re: Knife hinge fear - overcome!

#4

Re: Another Photo 

Dan Collins

>


img

Re: Knife hinge fear - overcome!

#5

Re: Third Photo 

Dan Collins

>


img

Re: Knife hinge fear - overcome!

#6

Ellis Walentine

Nice work, Dan

Ellis Walentine

>Beautiful job on the cabinet, Dan. Glad the knife hinges worked out for you.

Ellis

Re: Knife hinge fear - overcome!

#7

JL

Nice Dovetails.

JL

>

Re: Knife hinge fear - overcome!

#8

Re: Knife hinge fear - overcome!

Richter

>Very nice work. I love the colors and grains of the wood and how prominent they are. What kind of finish did you put on it?

Re: Knife hinge fear - overcome!

#9

Re: Knife hinge fear - overcome!

Dan Collins

>I put on two very light coats (1 lb.)of blond shellac, then 3 thinned coats of satin wipe-on polyurethane. I am always looking for the happy medium between applying enough finish to bring out the rays and grain without making it look like there is a plastic film on the wood. I wipe on all my finishes primarily because it is so much easier, particularly if I use very thin finishes. Dan

Re: Knife hinge fear - overcome!

#10

Very nice!

Tony - Memphis

>

Re: Knife hinge fear - overcome!

#11

Outstanding.

Don Orr

>Beautiful Dan. That is what I aspire to someday. I'm just getting started as you can see from my post below.

Re: Knife hinge fear - overcome!

#12

Re: Knife hinge -NO FEAR, great job!

Bob Entwisle in NJ

>Dan,

Nice work, I'm glad the hinges worked for you, (I knew you could do it!)

Re: Knife hinge fear - overcome!

#13

Re: Knife hinge fear - overcome!

Jim Dillon

>Dan,

Beautiful cabinet and the colors and grain sure do make it a special piece. Thanks for getting back to us regarding your knife hinges - they look super!

Jim