Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Makita drill problems

Posts

Makita drill problems

#1

Makita drill problems

Howard in Bethesda

>I have a 3/8 inch 14.4 volt Makita drill and a 12 volt Makita impact driver with 2 batteries for each and 2 chargers. Both are about 6 years old. Up until this week both were working fine. Now both of them have little to no torque and the drill also runs slower than normal. I have tried charging the batteries in both chargers in case the one of the chargers was faulty. I also checked the brushes and they are OK.

It seems very strange that both Makitas would fail at the same time. Any ideas what may be happening?

Thanks

Howard

Re: Makita drill problems

#2

Re: Makita drill problems

Bill Houghton, Sebastopol, CA

>Sure sounds like failed batteries to me. Odd that both (all?) batteries would fail at the same time.

Do those have replaceable brushes? If they do, have you checked brush length?

Re: Makita drill problems

#3

Re: Makita drill problems

Howard in Bethesda

>I checked the brushes and they are fine

Re: Makita drill problems

#4

Did they get frozen, by any chance?

Alexander Grigoriev

>

Re: Makita drill problems

#5

Re: Makita drill problems

Grant in Iowa

>Sounds like the batteries are at end of life to me, but it could also be a failing charger. Suggest you find a local dealer and ask them to isolate the issue for you. I bet they'd place a battery on their charger for a while to help you determine if it is the charger or the batteries. Our retailer does this for free, though I'd feel obligated to buy something to compensate them for their time... Maybe take along the whole kit and see if they have a good battery to test your drill and impact driver while you are at it.

If you are handy, you could also check the voltage on the batteries once they come off the charger to see if they are up to snuff. Even that wouldn't necessarily mean the batteries are good for certain, however. A bad battery will often register full voltage on a meter, but will still not deliver much current.

Does your charger have a "bad battery" indicator light?

FWIW,

Grant in Iowa

Re: Makita drill problems

#6

Re: Makita drill problems

John E in SC

>Had pretty similar thing happen w/ my Makita, but I only had one set of 2 batteries. This was also for a 14.4 volt drill, and both of the batteries crapped out at exactly the same time. Seemed pretty weird for 2, and weirder for 4, but that's what mine did. Bought new batteries off Amazon much cheaper than I could find them elsewhere, and works like a champ again.

John