Maybe a link?
Keith Newton------WebKitFormBoundaryV6MZb+tiOpocz6
>If you are talking about the blade with a handle set, I can't say, but I use some of the blades in a powered head, and I like them pretty well.
Of course, it depends on your own personal needs. I started carving back in the sixties, and back then couldn't even find any carving tools in my area, so I made most of my own as I was starting out. Later, as catalogs were offering full sets, lots of friends got sets that anyone could envy, but they were not earning their livings with them.
When carving jobs came along, I would usually add a few more tools. Finally some years back, I added an Automach head, and some of these tips. With a good power-head, sharp tool, in the right hands, there is just no way that anyone can keep up with these tools over the long haul.
Of course, I have to admit, that my hands are a wreck compared to what they once were. But even if you were talking about just the blades and handle. I have always like the control and intimacy of a short blade in a comfortable handle for small carvings, where you may be holding the work with one hand or lap or knees and the tool in the other.
However, I think the tang or shank is a little limber, if you are not pushing straight down the shaft. If your force is not down the shaft, you could bend the shank pretty easily. But when you put it in a power head, then just push it through the wood, you can go to town.
I don't know how any professional could do any carving without these tools. But then again, I am just talking about the finished cuts after using lots of other faster cutting / grinding tools.