Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

help / Parts for a b325 16"planner

Posts

help / Parts for a b325 16"planner

#1

help / Parts for a b325 16"planner

Marty

>Looking for help on fixing a b325 planer. This is a busy bee 16 x 8" planer, 2hp, 220v - has 4 blades. The issue: board got jammed and chain pin broke...that is fixed, however the chain / gears do not rotate the infeed/outfeed rollers. The gears appear not to be worn??, but I am not sure I can tell. Any thoughts / advice welcome.

Re: help / Parts for a b325 16"planner

#2

Re: help / Parts for a b325 16"planner

GalenV

>Just going from bad memory and may be wrong model.

Where does the drive rotation stop just the rollers or knife as well?

Motor belt drives the knife, both pulleys turn and shaft to knife turns? Belts not slipping or keys in shafts not sheared?

If ok Knife rotates.

Knife rotates gear box.

Gear box output shaft turns? If no problem inside gear box. Tooth in a gear broke off or a gear shaft key sheared?

Gear box ouput sprocket drives one roller, does shaft and sprocket rotate? Shaft turns but not sprocket? Sheared key? Was this the chain that broke?

That roller drive second roller by chain and sprocket, Niether must rotate or do they and key sheared? Is this the chain that broke?

Random thoughts in my head.

Galen

Re: help / Parts for a b325 16"planner

#3

Re: help / Parts for a b325 16"planner

Marty

>Thanks...some more info:

3 belts turn the knives...this works and the Knives in turn drive the rollers via a gear box. On the end of the Knives is a sprocket sprial teeth about 1.5in long, 1/2 in diameter - teeth look ok this goes into the gear box where there are 3 gear sprockets that turn the fast rotating knives to a slower speed to turn the rollers....The knives always turn, but when I put load on the rollers (even hand touch) the rollers stop. The chain that broke is outside of the gear box and is connected to two sprockets that turn the rollers. So I am checking the keys (so far they look good)...I will recheck the teeth.

Re: help / Parts for a b325 16"planner

#4

Re: help / Parts for a b325 16"planner

GalenV

>Sounds close to model but sounds like it is only has one chain around three sprockets not driving one roller than the other by second chain.

Gear box was oil filled and never seen inside.

It does sound like a sheared key on one of the gears. If teeth were too bad it would not even drive. Worn badly I would think you would hear gears "skipping" when you stopped rollers. Imagine a bearing could be going bad and allowing gear to pull away but again would think you would get sound. Maybe no sound if it was on the spiral or worm gear and as it probably has less "tooth" surface engagement.

Only guessing now from hear.

Galen.

Re: help / Parts for a b325 16"planner

#5

Re: help / Parts for a b325 16"planner

Marty

>Thanks for your help...problem solved...it was a sheared pin....the gear that drives the chain has (2) pins...one was OK and the other was sheared. I re-checked after reading your post this am and sure enough that was the problem....thanks for your help.

Re: help / Parts for a b325 16"planner

#6

Just keep your fingers out of it now! :>)

GalenV

>