Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

poor dado cuts

Posts

poor dado cuts

#1

poor dado cuts

otterville

>I have a Powermatic Artisan table saw and a 6" Freud dado set. I can never seem to get dadoes with smooth bottoms, no matter what the size. It looks to me like the outer blade is moving up and down slightly over top of the arbor threads, but I can't be sure. Has anyone experienced this problem? Cheers

Re: poor dado cuts

#2

JL

Re: poor dado cuts

JL

>I usually don't get absolutely smooth cuts either. So I clean them up with a rabbet plane.

Re: poor dado cuts

#3

Re: poor dado cuts

wooden leg

>When I bought my new dado set, I got bad cuts until I had it resharpened. I made sure the guy had the tops level, it seemed to do the trick. By the way I have the same saw. Dave

Re: poor dado cuts

#4

Re: poor dado cuts

Charles M

>It is not uncommon for an arbor to be machined under size. Other possible problems that cause similar results are an undercut between the threaded and non-threaded portion of the arbor and damage/scoring of the arbor. Can you measure the arbor along its length to check for variance? Does the fit of the blades change from one end to the other as you slide them on?

Charles M

Freud America, Inc.