Router bit question (I don't have to worry about.. *LINK*
JL
>noise though). I was thinking about Ralph Turney's question and ya'lls answers about spiral bits. I currently use straight bits to do my plunge cutting. I have a variety of sizes in 1/4" shank. I do have several bits (1/4", 1/2" and 3/4") with a 1/2" shank. I was thinking about getting a spiral bit to use in cutting mortises. I was figuring on 3/8" or possibly 7/16". Would the cutting length be enough to do a decent mortise (1")? Or would the "taper" from the 1/2" to the final diameter interfere?
I was thinking about getting an upcut bit as this is going to be used to make mortises.



