Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Threading metal rod

Posts

Threading metal rod

#1

Threading metal rod

Sawman

>I have some dies and I need to thread the end of some metal rods. I cannot seem to find a chart that shows what size diameter rod you use with a specific die. The charts show taps and drill sizes but..

Any leads? BTW the die is 3/8" cannot recall the thread as it is out in the barn.

Thanks

Re: Threading metal rod

#2

Re: Threading metal rod

Ray Thompson

>The sixe of the metal rod will be same as die size.

Die size 3/8 the rod should also be 3/8.

Ray in WNC

Re: Threading metal rod

#3

Re: Threading metal rod

GalenV

>If the die is 3/8-16NC or 3/8-24NF it is a bolt die for 3/8" rod.

If the die is 3/8-18NPT then it is a pipe threading die for 3/8 pipe that is .675" OD.

Since you were not sure of thread of the die or rod to use.

Re: Threading metal rod

#4

Re: Threading metal rod

Sawman

>Thanks for the replies! Got it done.

Re: Threading metal rod

#5

Re: Threading metal rod

Ray Thompson - Middletown,IN

>Ray, send me an email, I have a question for you.

Ray