Grand daughter Christmas Present
Lee Schierer - McKean, PA
>This is a cherry and maple jewelry box I made for my grand daughter as a Christmas present . The three trays are removable and when removed expose a larger divided compartment below. The center partition of the lower compartment is removable if desired. The wood is all natural color with a clear semi-gloss lacquer finish.



The box is made from pieces of 3/4 x 5-1/2 cherry crown molding. The only tools needed to make the box were a router and a TS. Cut the crown molding to lengths needed with the TS set on a 45 degree bevel cut. To make good corner joints this 45 degree cut needs to be exact and opposite sides have to be exactly the same length. This box is about 10 x 15 x 6 outside 8 x 13 x 4 inside. Once the sides pieces are cut, cut a groove near the bottom for the bottom board of the box. Cut out the bottom board and the top and you are one on the TS.
To form the leg cut outs, I made a jig for use on my router table with a guide bushing and 3/8" dia up spiral router bit. The jig guides the cut and insures the height of the cutout is all the same and finished quality. You could also use a bandsaw, but would have to do a lot of sanding to get rid of the teeth marks. I attach the pieces to my jig with double sided tape. Once the legs cutouts are done, I glue up the box. On the assembled box and lid, I mark the locations of the two brass cylinder hinges. This has to be very precise so the hinges will press into the holes. There is no adjustment on this type of hinge. I drill the holes to the desired depth on my drill press. Then after the holes are done, I put a 45 degree chamfering bit in the router and set the fence to remove material from the top edge of the box and back lower edge of the top until the bevel is halfway across the hinge holes. I shim up the front edge of the lid about 1/16-1/8" so that the bevel on the back side ends up at about 47 degrees so the lid leans back slightly when fully open and stays open more readily.
A trial assembly verifies the hinge fit and function then its off to finishing. For final assembly I line the hinge holes with superglue right before pressing in the hinges. This glue insures the hinges stay put better. That's pretty much it for the box.
The trays are straight forward except for making the thin stock. The tray corners joints are locking rabbet joints cut on the TS. For 1/4" stock the 1/8" saw kerf is ideal for making this joint which almost doesn't require glue.
Thanks for viewing,
Lee





