Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

shaper fence

Posts

shaper fence

#1

shaper fence

Bill Sams

>Yesterday I built this shaper fence with sliding dovetail gibs that is modeled after a Felder design.

the pics should be self explanatory to a large degree. Essentially 2 pcs quartersawn poplar milled to 1-1/8" x 6" x 20" with dovetailed grooves, with recessed holes below the grooves which accept the bolts which fasten it to the cast iron fence of the shaper.

the gibs were made using the another pc of poplar with the same dimension, using the same router bit, but adjusted the spacing so the gibs would fit the grooves. These gibs were milled on both sides of the board, then resawed on the bandsaw slightly higher than the actual fence height. The hand planing the gibs level with the surface.

the whole point is to eliminate the tendency of stock wanting to "cave" in towards the cutter while milling by having at least a small bit continuous fence. The gibs slide to any position and can be fastened with small drawer slide screws if necessary

Hope all that makes sense.


img

Re: shaper fence

#2

Re: shaper fence 

Bill Sams

>


img

Re: shaper fence

#3

Re: shaper fence 

Bill Sams

>


img

Re: shaper fence

#4

Re: shaper fence 

Bill Sams

>


img

Re: shaper fence

#5

Outstanding piece of work Bill. I think I have..

Art Silva

>just found a new fence for my Router table. Making zero inserts for a series of bits and cutters is a PITA. With your rendition all it takes is to loosen a few fasteners and adjust. I like it! Thanks for posting this home grown solution. Art

Re: shaper fence

#6

Re: Outstanding piece of work Bill. I think I have

Bill Sams

>Thank you Art. That's why I posted it, so hopefully others would make use of the idea.

I also will probably make another one for my router table. I used a 1/2" dovetail bit for the shaper fence but it "might" work well for using a smaller dovetail, ie 3/8", for use with the router table to accommodate the smaller cutter profiles.

I also made lots of extra gibs, so when you need one you have them.

Take care....