Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Dead Table Saw Switch

Posts

Dead Table Saw Switch

#1

Dead Table Saw Switch

Rick in Jackson

>Need some help on replacing this rocker switch from my Powermatic 63A Artisan 10" table saw. It is part number 6285322 in the parts manual. I bought this saw in 1989 and I have searched Google for every combination I can think of and can't find anything. I removed it fron the saw and when I opened it up, one of the contacts came out, looking at it closer, it looks like it shorted some how and it came off the connection point. Is there another switch I can use? The is for connectors on the back, two for the motor and two for the plug. I am a lot of things but I ain't no electrical wizard :)The switch is rated 20A 125V AC and under that 12A 250V AC.

Thanks for your help, Rick


img

Re: Dead Table Saw Switch

#2

Jim DeLaney, Austintown, Ohio

Re: Dead Table Saw Switch

Jim DeLaney, Austintown, Ohio

>Jet Tools (actually WMH Group) acquired Powermatic a couple years ago, so Jet may be able to come up with a switch.

Failing that, there are several 'generic' switches that may work. The one on my older Delta jointer looks just like that one, and so does the switch on several Sears Craftsman tools I've seen.

Also, a decent electronics shop (NOT Radio Shack) might be able to help you.

Jim D.

Re: Dead Table Saw Switch

#3

Re: Dead Table Saw Switch

Chuck in ND

>I don't know what you can spend, or what type of fence you have on your saw, but maybe it would be time to upgrade to the newer switch and mount from a 64A. It would probably be alot easier to use.

Re: Dead Table Saw Switch

#4

Re: Dead Table Saw Switch *LINK*

Dave Paine

>Jim,

If Powermatic/Jet cannot help, try looking at Grizzly Industrial. A good selection of switches for saws, planers, etc. The attached link is one exmple which looks similar. This one is only 10 Amp so not your rating, but just put "Switch" in the search box and you will get many others. I expect one of these can be made to fit.


http://www.grizzly.com/products/Toggle-Safety-Switch/G8989

Re: Dead Table Saw Switch

#5

Re: Dead Table Saw Switch

Rick in Jackson

>thanks for the responses to the question everyone..I'll look into it. I did find this on Rockler so if the Grizzly link doesn't solve the problem, I guess I will just tie the whites blacks and greens together and plug into this safety switch. Thanks again and Happy New Year...


img

Re: Dead Table Saw Switch

#6

Re: Dead Table Saw Switch

Rick in Jackson

>Dave - I ordered the switch from Grizzly shown below, higher rated that the Rockler switch and it is about half the cost. I'll figure out how to mount it when it arrives, thanks again for the tip.


img

Re: Dead Table Saw Switch

#7

Re: Dead Table Saw Switch

Chuck in ND

>Rick, I think the switch mount that the 64A has should work to mount that switch, or if your good with metal you can make your own mount. I have made several. I guess it depends on how much time or money you have.


img

Re: Dead Table Saw Switch

#8

Re: Dead Table Saw Switch 

Chuck in ND

>


img

Re: Dead Table Saw Switch

#9

Re: Saw Switch mount

Chuck in ND

>The Powermatic 64A switch mount is part number 6291367, the price is $4.51.