Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Going back to WoodWkng Show Tomorrow

Posts

Going back to WoodWkng Show Tomorrow

#1

Going back to WoodWkng Show Tomorrow

Frank in Forest Hill

>Went to the show in Baltimore today and checked out things before I buy.

I am just about ready to hop on the Powermatic 1791216K (14inch,bandsaw) with the 6 inch riser block. I came home and read several bad reviews about having to cut off the aligning dowels on the riser block to prevent severe misalignment.

It is hard to tell how old these reviews are and to determine if this problem has been corrected. Does anyone have any recent incite into this situation. Thank You,

Frank on Chestnut Hill

Re: Going back to WoodWkng Show Tomorrow

#2

Re: Going back to WoodWkng Show Tomorrow

ScootC

>I can't help with your question, but I was wondering what your impression of the show was. Specifically, the tool vendors and their inventory. I was thinking of checking out the Steel City table saws but since I'm down in NoVa I don't want to waste the trip up to Balt. I can always wait until the Chantilly show in March.

Thanks.

Re: Going back to WoodWkng Show Tomorrow

#3

Re: Going back to WoodWkng Show Tomorrow

Steve in Denver

>When the show was in Denver, back in Nov, a couple of obvious vendors MIA were Leigh and Incra.

Re: Going back to WoodWkng Show Tomorrow

#4

Re: Going back to WoodWkng Show Tomorrow

Frank in Forest Hill

>Well.... the usual hawkers are there.... I also saw Veritas had a good display you could grab and touch about fifty hand planes and other items. Fein was there and I did see the steel city name but as I recall the items they had were small and not enough to draw me to the table.

A couple of the local wood wkng folks were there .... Skarie and Cayce.

Good Luck,

FFG

Re: Going back to WoodWkng Show Tomorrow

#5

Re: Going back to WoodWkng Show Tomorrow

ScotC

>Thanks for the info. I'll probably just wait until March.

Good luck with the Powermatic.