Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Drum sander sleeves?

Posts

Drum sander sleeves?

#1

JL

Drum sander sleeves?

JL

>I picked up an old drum sanding kit at a yard sale. I can get the bolt out relatively easily. Try as I might though, I can't seem to get a new sleeve on the drum. It is a 1" drum with a 1" x 2" sleeve. I've managed to change the sleeves on the other drums, though they are kind of tough to change out also.

Re: Drum sander sleeves?

#2

Re: Drum sander sleeves?

Barry Irby

>JL, I have a very old Sears drum sander or two and I have the same problem. I was stingy with the sanding drums and left the thing in the drawer until it dried up. I think the rubber gets stiff with age and does not contract when you release the pressure. Maybe you could warm it up or just loosen the pressure on it and let it sit a while. Try soaking it in hot water for a while. Don't know if there is anything you can do to rejuvenate the rubber.

Re: Drum sander sleeves?

#3

JL

That is not good news. Well, it only cost $1.

JL

>And I do have a nice stand. I can always just use them and eventually replace them.

Re: Drum sander sleeves?

#4

Re: Drum sander sleeves?

Phil Joines in Krum, Tx

>I've forgotten to loosen the bolt on my Delta Boss several times. I put the drum on the floor, lay a board on it and roll it back and forth putting pressure on it with my foot.