Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

making compound picture frames?

Posts

making compound picture frames?

#1

making compound picture frames?

Dave in St Paul, MN

>I remember the old, maybe still current, ShopSmith info-mercials where they would make the picture frames that had 45 deg corners with a compound cut. The compound cut allowed the inside to be "in" further, with the outside perimeter "out".

I have a Rigid compound slider miter saw that tilts and zigs and zags in every way imaginable, and probably even some I haven't discovered yet. I set the table at a 45 degree angle for the corner, then tilted the blade a few degrees to create the shadowbox effect. What I found was that when I tilted the blade and made my cut, the 45 corner was no longer 45.

Any book recommendations, helpful websites, or experienced picture frame makers with some pointers for a frame-building novice? 8-) I've done trim carpentry and so use my CSMS efficiently, just not for pic frames, YET.

Re: making compound picture frames?

#2

Re: making compound picture frames? *LINK*

Rick Christopherson

>I'm going to humbly mention this and hope that I don't sound like a broken record since I just made a similar posting yesterday. The timing puts this too close on the heels of another topic with a similar answer. Please forgive me, but the topic is applicable.

In the Festool Kapex Supplemental Owner's Manual that was just released, I not only describe the compound cuts you wish to complete, but this PDF file actually contains a built-in electronic calculator that does all of the math for you as well. I have never seen a PDF file that had a built-in calculator like this, so I am kind of proud of the fact I figured out how to embed one like this.

Just FYI, but in most cases, these cuts could be made with a standard miter setting, where the frame/moulding is tilted against the fence. I discuss this topic as well, so you can read the information and see which method is best suited to your application.


Kapex Supplemental Owner's Manual

Re: making compound picture frames?

#3

Re: making compound picture frames? *LINK*

Fred Davis

>Adding to Rick's info on using a simple mitre setting , I use a Makita 14 " Mitre saw, get some large or what even size you want the frame stock to be in a crown moulding.

Adding a 3/8ths by 3/8ths atrip to the widest back edge to carry the picture will give you a nice shadow box

FredD


http://picasaweb.google.com/lh/photo/nLRye6y6KWomcalTRv79ig?authkey=nS_Xut_DWYA&feat=directlink

Re: making compound picture frames?

#4

Re: making compound picture frames?

J. Roberts

>Check the Articles/Badger Pond section for Compound Miter Formuls by David Wright. This gentleman saved me a lot of grief when I was making frames. It really works.

Re: making compound picture frames?

#5

Re: making compound picture frames?

paul waddle

>I used to make lots of compound frames on the table saw,but I did not have the advice of the learned responses given hear. If you have the electronic read outs,you can set it dead on. My old method is to cut 45*groove in a pine 2x4. Attach the 10-12" gooved 2x4 board to the miter guage. Swing the miter to 45* and insert the frame stock for one cut in the back of the goove, and the corresponding side in the foward side of the board. This cuts from the face of the molding. Seems like one or the other cuts,the face of the molding was down, and the other up. If you have a good blade,this gets it very close. The problem I had was and still is,how to clamp the rascal... Well, I tried to help... pw