Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Electric Motor Help needed!

Posts

Electric Motor Help needed!

#1

Electric Motor Help needed!

Sawman

>I have a blower on a coal furnace that I want to reduce the speed on.

What kind of motors can 'speed controls" be used on? I am having trouble finding understandable info.

It is a dayton Blower but since they have not"tested" this they cannot recommend it.

Re: Electric Motor Help needed!

#2

Re: Electric Motor Help needed!

Bill Howatt

>If the speed control is the type to be used on a router then it is suitable for universal motors which have brushes. Other motors, the ones typically found on furnace fans, are induction motors and these controls will not work with them. Induction motors for most practical purposes are fixed speed motors. Some have more than one winding and selecting the windings will give different speeds but this doesn't seem to be your case.

Bill

Re: Electric Motor Help needed!

#3

Jim DeLaney, Austintown, Ohio

Re: Electric Motor Help needed!

Jim DeLaney, Austintown, Ohio

>Most furnace fans are belt driven. Your best bet would be to change out the pulleys and belt - a smaller motor pulley; a bigger fan pulley; or both.

Re: Electric Motor Help needed!

#4

Re: Electric Motor Help needed!

Barry Irby

>Better be careful. Changing the speed of the motor changes how much air it moves and that changes the air temp. Slow the air down and it gets hotter, speed it up and it gets cooler. This affects the operating temp and temp swing on the heat exchanger. So, if you slow it down, the heat exchanger runs hotter and the thermal stress each time it heats up and cools down is greater. Hard to predict how much this will shorten the life of the heat exchanger.

OTOH, most of those fans have several windings and you may be able to select a speed that suits you better, but I don't have the experience to tell you how.

Re: Electric Motor Help needed!

#5

I've never seen a furnace blower *LINK*

Mark Goodall - ATL - tooljunkie

>I've never seen a furnace blower motor that wasn't a multi-speed motor.... at least 2-speed, if not 3. Heating requires a slower speed speed than air conditioning, so around here all furnace blower motors have at least 2-speeds.

These induction (not-universal) motors have extra sets of wires, and the speed is determined by which wires are connected.

There's some information about using these blowers for a workshop below, perhaps you'll be able to get some ideas from that.

Happy Woodworking!


http://www.happywoodworking.com/MotorWiring.html