Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Router speed

Posts

Router speed

#1

John Pierce

Router speed

john pierce

>I just fired up my PC 8529 router after a long absence of any work. I discovered that it spun up to speed and then promptly began to shut down, finally arriving at a very low, un-useable, speed where it continued to turn until I turned the power switch off.

Does anyone have an idea what may be behind this strange behavior?

John

Re: Router speed

#2

Re: Router speed

Bob Entwisle in NJ

>First off, I'm not familiar with this router.

That said, barring a mechanical issue, such as seized bearings etc, which should be apparent from (unplugged) manually turning the shaft etc. I would take a look at the variable speed controls, specifically the speed adjustment control, it sounds like you are in permanent low speed mode, could be dirt or dust obstructing a contact in the variable speed adjustment control.

Re: Router speed

#3

John Pierce

Re: Router speed

john pierce

>Well, I found the problem. It was the speed control which apparently was at a dead spot. After I moved the speed control the Router worked fine.

John

Re: Router speed

#4

Dust in the reostat

Phil Joines in Krum, Tx

>There's probable some dust in the pot. Sounds like a gentle blow with compressed air is in order.