Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Way OT Microwave spit fire question?

Posts

Way OT Microwave spit fire question?

#1

Way OT Microwave spit fire question?

Barry Irby

>Put a cup of tea in the Sharp microwave and a flash of fire came out of the right side of the oven. Turns out there is a little panel of some sort of material that looks like it was made from mica. It was white with a sort of silvery cast. It snaps into slots in the side of the oven and covers a rectangular port where the microwaves (?) enter the oven. It is smokey and charred. I removed it by flexing it slightly and taking it out of the slots. It's brittle. Is it safe to run the microwave without it? Can I get a replacement? (Last time I went to a repair site they admonished that us mere mortals should not work on microwave ovens.)

Re: Way OT Microwave spit fire question?

#2

Re: Way OT Microwave spit fire question?

Bill Howatt

>If that is where the microwaves enter the oven cavity from the magnetron, it may just be a symptom rather than the cause. The cause could be the magnetron has gone.

Can't really say what the effect might be in running without it although if the magnetron is fried it won't run anyway.

Bill

Re: Way OT Microwave spit fire question?

#3

Re: Way OT Microwave spit fire question? *LINK*

John McGaw

>I would avoid running the microwave without the shield in place. It is there to keep crud from entering the waveguide where it would wreak havoc. You can easily purchase a replacement and, as you've discovered, it is easy to remove and replace. But before ordering a replacement you might want to do a quick check to verify that the rest of the system is still working -- heating a cup of water to boiling and timing it would be a good test as long as you know roughly how long it should take. If the oven still heats then replacing the shield would be next before doing any "real cooking" in the oven.

The linked company will sell you any sort of microwave parts you want -- even the dangerous ones.


Sharp Microwave Waveguide Shield

Re: Way OT Microwave spit fire question?

#4

concur: symptom, not necessarily cause

Bill Houghton, California cold in Sebastopol, CA

>I suppose if you had a major buildup of crud on that shield that was ignited by the microwaves, you could have had that result - but I'd look more closely at the area around that panel. If it was designed to let microwaves through, it shouldn't be something that's heated up by them. Is there charring in the region behind it?

I hope your microwave is plugged into a good, grounded GFCI outlet, if you're going to test it out after this incident.