Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Was this due to blade deflection?

Posts

Was this due to blade deflection?

#1

Was this due to blade deflection?

North of the Border

>I ripped a hardwood (on a full-kerf blade) and the rip cut looked like the one shown in the picture. Was it because of blade deflection?

Such scoring still appeared even if the piece was cut on a cross-cut sled.

Any comments would be welcome.


img

Re: Was this due to blade deflection?

#2

Re: Was this due to blade deflection?

Stuart Hough

>Could be one of three things in my estimation. Most likely you fed the stock into the blade too quickly. The other two thingas that make sense are either your blade has a chipped tooth, or you need to clean the blade. JMHO.

Re: Was this due to blade deflection?

#3

Re: Was this due to blade deflection?

Chuck in ND

>Or the arbor is out of alignment, or the fence is out of alignment.

Re: Was this due to blade deflection?

#4

I think I agree with Chuck

Scott in Montana

>Sometimes when your blade is out of alignment with your saw's tabletop or out of alignment with your fence, you will contact the blade at a very slight skew causing this type of marks.

I have noticed when out of alignment that the wood seems to contact the blade a second time on the back edge of the blade on the way through. This will sometimes cause these marks.

Best regards,

Scott in Montana

Re: Was this due to blade deflection?

#5

Re: I think I agree with Chuck

Fred Davis

>If that is the only blade that produces the heeling cuts, it could be a blade needing a good saw shop that can side grinde the teeth, if all of your rip cuts look like that , regardless of the blade then you need to realign the fence with the blade (most common cause) and or the saw blade with the mitre slot, doing that first, if it is out .

FredD

Re: Was this due to blade deflection?

#7

Re: Was this due to blade deflection?

Rick Christopherson

>It is hard to say what caused your burning without knowing what blade you used. If it was a coarse ripping blade, then your feed rate was way too slow. However, the closeness of the minor saw marks and the spacing of the major saw marks, my guess is that you were using a fine tooth blade, and that will cause burning. Your blade height doesn't look too bad, but it could have been slightly higher, especially if it was a fine tooth blade.

As for the saw marks, you'll notice that they are periodic, with minor marks packed very close together, and the major marks occurring at regular intervals. What I can't tell from the picture without knowing the blade type, is whether the frequency relates to the blade rpm or not. If you used a ripping blade, the frequency is too far apart to be one revolution, but if it was a fine tooth blade, then it is one revolution.

If you were using a fine ATB blade, look for a tooth that has a chip in the top bevel. Also check the blade for flatness and your arbor flange for runout.

If you were using a ripping blade, then look for something that could set up harmonic vibration that would span more than just one revolution. If its a contractor's saw, check the motor and drive belt. The drive belt could have a hard pulley bend if it had been sitting for a long time without use.