Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Please...help with christmas project needed!

Posts

Please...help with christmas project needed!

#1

Please...help with christmas project needed!

Gary

>I am in the midst of finishing a couple of christmas projects, and have run into a snag. In the picture there are two pieces shown. I have made three of the same pattern, with one of them being a different species of wood. The one NOT shown has had no problems. However, the two shown below have reacted differently. Here is the scoop: After sanding, I applied 2 coates of clear shellac (within it's shelf life). These coates dried normally, with no difficulties or unexpected results whatsoever. After the shellac I applied 1 coat of wipe-on-poly (I think it is Minwax). I used this poly on a different project a couple of weeks ago with no problems, and also on the third piece, again with no problems.

However, on these two pieces, there is still a definate "tacky" feeling to it. It has been a week, or so, and it's not getting any better.

Two questions, first, do you know what kind of wood this is? I think it's an unusual one, but I don't remember the name. Second, what do I do? Can I apply a coat of shellac over this "tacky" poly, then call it good? Another coat of poly?

Let me know!


img

Re: Please...help with christmas project needed!

#2

Re: Please...help with christmas project needed!

Paul Woolson

>Looks like flatsawn Bicote to me. But it's kind of hard to tell from a photo.

If I were you I'd sand off the poly and just finish with Shellac. If you go over the poly with shellac, you are going to have problems.

What are those items anyway?

Best wishes! Paul

Re: Please...help with christmas project needed!

#3

Re: Please...help with christmas project needed!

Chuck in ND

>If it's tacky I think it's going to be pretty hard to sand, the sandpaper will just gum up and really leave a mess. Perhaps striping it and starting over is the answer. Maybe let the shellac cure longer before applying a coat of a new batch of Poly. Or skip the shellac all together. Was the Poly you used old ? or was it a fresh can not stirred properly ?

Re: Please...help with christmas project needed!

#4

Re: Please...help with christmas project needed!

Earl

>Gary you didn't say what the weather has been like. I had this happen when the weather changed to cool and damp. I put it under a heat lamp and it cured rite up

Lotsa luck Earl

Re: Please...help with christmas project needed!

#5

Re: Please...help with christmas project needed!

Ken Platt (granby, CT)

>I'd guess that you ran into the known problem of some exotics which have oils that prevent poly from curing. Probably the problem piece had more oils, or it's shellac coat was a bit thinner, or perhaps a combination of those.

A heat lamp might help, but the quick way to take care of this is to wipe with mineral spirits until it's not tacky anymore, let it dry for a day or so, then as was already advised, finish it off with shellac if you feel you need any more finish.

I ran into this with some ipe. After I wiped off the tacky stuff, it looked fine, so I left it as it was.

Ken

Re: Please...help with christmas project needed!

#6

Re: Please...help with christmas project needed!

Clint Searl, at the base of Haycock Mtn

>Strip 'em with a MEC based stripper and shoot some rattle can lacquer.

Clint