Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

12 g extension cord length?

Posts

12 g extension cord length?

#1

12 g extension cord length?

Mitch from Canada

>Hey all,

My father in law wired my garage years ago...there is no breaker box at the moment. Everything runs direct from the house. I have a 22o line..(12 Gauge) running I figure about 60 feet to a plug receptacle in the garage. I was going to add a 25 ft extension cord to my Unisaw. My father in law (an electrician)said that 25ft of 12 gauge extension cord will work without having to worry about voltage drop. Does this make sense to you guys? How long can you run 12 G up to a receptacle and then how long after that?

Re: 12 g extension cord length?

#2

Father in law must know amp draw !

GalenV

>

Re: 12 g extension cord length?

#3

Re: 12 g extension cord length?

John K Jordan

>Depends on the total amperage needed at the far end.

Re: 12 g extension cord length?

#4

Re: 12 g extension cord length?

Alexander Grigoriev

>100 ft of 12 gauge cord (200 ft of wire) have resistance about 0.3 Ohm. Suppose, your equipment draws 10 A. Then voltage drop would be 3V, which is pretty much nothing.

Re: 12 g extension cord length?

#5

Re: 12 g extension cord length?

Fred Davis

>3 V. drop sounds insignicant, until you run soemthing senstive to any voltage drop.

I had a couple of finish Carpenters buy a unnamed brand of pancake air compressor and it was so senstive to a volttage drop that the only way it woud run was if it was plugged directly into a wall outlet.

Extension cords regarless of length would not work.

They complained to the hardware store and were told that particular brand and model pretty much was worthless as a portable unless you always hade a close to work outlet

FredD

Re: 12 g extension cord length?

#6

Re: 12 g extension cord length? *LINK*

GalenV

>This site might be of interest to do your own calcs.

You can also find the allowable voltage drop allowed by Canadian electrical code on line.


Voltage Drop Calculator

Re: 12 g extension cord length?

#7

long-range compressor

John K Jordan

>When I run a pancake compressor to use a nail gun in an outbuilding on the farm I use a relatively short large-gauge extension cord and LONG hoses. (I plug multiple hoses together with quick-disconnect fittings.) This effectively increases the volume of the compressor as well, probably doubling it.

JKJ

Re: 12 g extension cord length?

#8

Thanks for the help everyone. NM*

Mitch from Canada

>