Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Laminating Plywood question

Posts

Laminating Plywood question

#1

Laminating Plywood question

Barry Irby

>I made some pieces of veneer out of a walnut crotch I had. They are about eight by twelve. I want to laminate them onto thin plywood as tops for boxes. I thought I could by a "door skin" piece of plywood at one of the borgs, but alas they don't have them any more. Door skins are or were pieces of 1/8" plywood 3" by 7'.

So, several questions.

Would 1/8" tempered hard board work just as well? (I have some, but I think it is heavy.)

Where can I get 1/8" plywood?

or Should I just cut a center lamination out of poplar (?) and laminate a ply on each side? Should you turn it cross grain?

(I don't have a vacuum press, so I am using cauls and clamps.)

Any tips would be appreciated.

Re: Laminating Plywood question

#2

Re: Laminating Plywood question

Scott in Montana

>Good morning Barry!

I use 1/8" baltic birch for small lamination projects. It's very smooth on both sides. The only door skin I've purchased was quite smooth on one side but rough and ugly on the other. Now this could have been a rare example; I don't know. Baltic birch here runs about $15 of 1/8" 5x5 sheets. It's an impecable material to laminate to.

Good luck,

Scott in Montana

Re: Laminating Plywood question

#3

Hobby shop

paul in AZ

>Try a hobby or model airplane/boat shop for small pieces of thin plywood

Re: Laminating Plywood question

#4

JL

Try a building supply store, rather than a BORG

JL

>I typically get Lauan plywood in 1/4" and thinner sheets for the sets at the playhouse at our local building supply store. I get it in 4' x 8' sheets though. I've seen small pieces at Dick Blick's (Art supply store) - but I didn't price them.