Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Sanding spirals? X posted on Turning

Posts

Sanding spirals? X posted on Turning

#1

JL

Sanding spirals? X posted on Turning

JL

>So, I tried doing it by hand a "double barley twisted ribbon". And by "hand", I mean by hand. I mapped out the pattern on the turned blank, cut a kerf with my saw and rasped out the coves. I believe the column is mahogany and the top and bottoms are either maple or birch (it was free kiln dried wood, I wasn't going to ask their provenance). Needless to say, I had to sand it to get the rasp and file marks out.

I sort of want to do this again, with some thinner pieces. I don't want to spend too much time sanding though. Anyone have any better methods to sand the spirals? TIA


img

Re: Sanding spirals? X posted on Turning

#2

Re: Sanding spirals? X posted on Turning

Fred Davis

>If you have access to a old Delta Moulding head that takes three cutters , I use mine with cove bits installed in it to rough out a cove, or cove shape on the table saw, sliding the stock by the moulding head against a angled fence.

This is much faster then doing the same thing using just the saw blade on a angle.

This should hog out most of you waste.

FredD

Re: Sanding spirals? X posted on Turning

#3

Re: Sanding spirals? X posted on Turning

Rick Christopherson

>I have one of those "long ago started, but never finished projects" of making hollow spirals for a fireplace surround. The reason why I set it aside for many years was the amount of sanding it required. I made a deal with a Dynabrade distributor, and they sent me a DynaFile. It allows for quick removal of material in tight areas and contours. For me, it was especially important for being able to sand between the spirals. The method I used for creating the spiral was to drill successive holes down the body with a forstner bit, and this meant removing the deep scallops from the sides.