What a klutz! :^(
Alan Young
>Sigh :^(... So I head down to the shop last night. My first task was to fix the foot on my black lacquered music stand. This fix in and of itself is small story that I'm skipping over other than to say I had the stand on a couple of sawhorses when I knocked it off and right into the side panel of the music cabinet I'm working on.This left a gouge in the veneered panel that was too deep to sand out.
The gouge is in the lower right hand corner of the panel.
I decided I had 3 options to pursue.
1. Finish the entire side panels in black
2. Place another sheet of veneer over the panel and reline that with more edge molding.
3. Create a "design feature" by inlaying a diamond pattern.
Here are some close ups of the nick.
It is approximately 3/4 of an inch long and 1/8 inch plus wide and deep. Too deep to sand out. I decided to tackle option 3 as an experiment.
I cut out a diamond from some 1/4 inch thick walnut stock.
After outlining the contour I routed and chopped the opening.
Then the inlay is glued in place and sanded flush.
I can now add more diamonds in the panel in agreed upon location to create a pattern. Now I have to let the client know what happened and what can be done. She'll have to make the decision.
Alan






