Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Laser Adjustment

Posts

Laser Adjustment

#1

Laser Adjustment

Frank Mutchler

>I have a Router Boss that uses two lasers to project an 'X' that represents the center point of the bit. The picture shows the 'X' with a tiny black dot made by a centering bit chucked in the router.

The two laser lines are a little 'fat' for my liking and so I would like to reduce the diameter of the beam that is projected in order to project a much finer 'X'. Are there any knowledgeable laser folks here who know if this is possible and, if so, how I might accomplish it? TIA


img

Re: Laser Adjustment

#2

Focus ?

Charles Yawn

>Are the beams focus adjustable? I don't know about your tool, but other lights are fat and fuzzy when out of focus. Charles

Re: Laser Adjustment

#3

Re: Focus ?

Frank Mutchler

>No focus adjustment is available. The switch can select either the laser of LED lights to illuminate the cut.