Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

lap joints question

Posts

lap joints question

#1

lap joints question

Matt- Los Angeles

>hey all,

long time no post. I seem to remember a cool way to cut lap joints on the table saw with no measuring. Did I make this up or does it ring a bell with anyone. I am trying to avoid having to cut exactly half. My eyes aren't good enough for those 64ths anymore...

thanks

matt

Re: lap joints question

#2

Re: lap joints question

Curly Smith

>Were you thinking of this:

"You need to adjust the height of the blade (or bit) so it cuts exactly half way through the thickness of your stock. But I don�t use a rule to set the blade height.

Instead, I start by setting the blade slightly below the half-way point. Then using a test piece (one that is the same thickness as my workpieces), I gradually sneak up on the height, see Fig. 1. To do this, just make a cut on the end of the test piece. Then flip the piece over and make a second cut on the same end. You should have a thin �sliver� left over. Now just raise the blade a hair and repeat the process, removing a little more from each side of the sliver until it�s completely removed. When it is, the blade will be set at half the thickness of the workpiece."

from this Woodsmith PDF: Cut Perfect Half Laps

Re: lap joints question

#3

Re: lap joints question

Matt- Los Angeles

>Curly,

thanks, yeah i saw that article too. No, I was thinking that if you make the cut in the first piece, then flip your mating piece upside down, mark to where the first piece was cut, then flip it over and cut at the same blade height without changing it, you create the perfect match by compensating for any difference + or - exactly half. Make sense?

maybe this came to me in a dream. I just can't remember where I heard it.

Of course this may not work if you have to make multiple passes on multiple boards.

Thanks for your reply...

matt