Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Upcoming project questions

Posts

Upcoming project questions

#1

Upcoming project questions

mdclor

>Good evening to all,

I will build a bed headboard (SHMBO doesn't want a complete frame) based on Robert Lang's Shop Drawings for Craftsman Furniture, page 98. This calls for M&T joinery of pieces up to 7.5 inches wide. I looked at the Shrinkulator and, if I did this correctly, it looks like the movement for QSWO will only be in the range of 0.03 to 0.06 inches. The RH in my shop is currently about 37% and I estimate the RH in the house may get to as low as 20% in the winter. We are located outside Albuquerque, NM. Now for my questions: 1. Am I understanding the calculations correctly? 2. For this movement, should I make 2 M&T's for each of the wide joints? 3. Is there any advice anyone would care to share in the making of this piece?

TIA,

Merle

Re: Upcoming project questions

#2

Re: Upcoming project questions

Bob Lang

>I think you'll be OK. I usually leave a bit of room in the width of mortises-mostly to be able to take them apart while fitting, but also to provide some room if some swelling takes place. The shoulders should cover up any shrinkage.

Bob Lang

Re: Upcoming project questions

#3

Re: Upcoming project questions

Clint Searl, at the base of Haycock Mtn

>I'm currently making a headboard similar to your description. It will have five separate vertical panels M&T'd into horizontal top and bottom rails. The hard maple tenons are from 6 to 10 inches in width. Our ambient humidity ranges from around 40% to 90% throughout the year, so I plan to accomodate any seasonal movement by limiting the glue area to the center 2-3 inches of each panel and running a couple bamboo dowel pins into the center area of the tenon from the back of the rail. I'm sure there won't be any problem.

Clint

Re: Upcoming project questions

#4

Re: Upcoming project questions

mdclor

>Bob & Clint, thanks for your replies. I feel much better now about moving forward with this.

Merle