Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Breadboard End Question

Posts

Breadboard End Question

#1

Breadboard End Question

Ken Krawford

>I'm going put breadboard ends on a desk top I'm making. The thought of end grain being visible from the front of the desk doesn't excite me.

What are my options for avoiding this problem?

Thanks.

PS - This is my first attempt at breadboard ends. Any tips or gottchas?

Re: Breadboard End Question

#2

One Breadboard End Answer

Lee Schierer - McKean, PA

>The biggest problem is dealing with expansion/contraction issues as the seasons change. I would recommend a sliding dovetail attachement and pin or glue only the center 2-3 inches.

Lee

Re: Breadboard End Question

#3

Re: Breadboard End Question

John E in SC

>From my reading of your question, you're OK with using breadboard ends, but just don't want the endgrain (of the breadboard ends) showing from the front of the desk, correct? If that's the case, I don't see why you couldn't just miter the ends of the breadboard before it's installed. Would probably use a bisquit or spline to reinforce the miter joint since it won't really have any endgrain to glue to. You could still slot it or use a sliding dovetail as recommended above, you'll just be "hiding" the end grain.

HTH,

John

Re: Breadboard End Question

#4

Re: Breadboard End Question

George@Colonel's Workshop-Havertown PA

>Yes Ken,

I think John's approach to hiding the end grain would work well, and is a better approach than my initial inclination. If you didn't want to miter the ends of the breadboard, you could "face" the bread boaerd end grain with very veneer strips, sliced thin enough so that any of the veneer's end grain would be un-noticeable at the edge of the application.

George

Re: Breadboard End Question

#5

Re: Breadboard End Question

Bill White

>John beat me to it.

Bill

Re: Breadboard End Question

#6

Re: Breadboard End Question

Ken Krawford

>Thanks for the suggestions. Since I have already glued up the top, mitering the ends might be a bit tricky. I would hate to ruin the top if I goofed.

Right now the Colonel's suggestion of veneer sounds like an easy way to solve me problem.

Thanks all for responding.

Re: Breadboard End Question

#7

Re: Breadboard End Question

Clint Searl, at the base of Haycock Mtn

>I think the suggestion was to miter the ends of the breadboard end piece. The top needn't be disturbed.

Clint

Re: Breadboard End Question

#8

What he said...

John E in SC

>is correct. I was suggesting just to miter the ends of the breadboard, which would then be installed exactly like a "regular" breadboard. Wish I knew how to do a quick drawing or something I could post here, but maybe someone else more skilled than I can help out!

John

Re: Breadboard End Question

#9

My Bad

Ken Krawford

>That was really dumb on me. Mitering the breadboard now makes perfect sense.

Re: Breadboard End Question

#10

Re: Breadboard End Question

Fred Davis

>Ken ,

this is more then likely away to late,but....

In the Sept/Oct issue of FWW , Russell Jensen has a mitered breadboard joint that the Japanese call "Kane tusgi" that is basically a Miterd /pinned bridle joint that would challenge the skill of anybody and the result is exceptional.

FWW showcases this joint in the Master class section and for a guy who wears his hat backwards , Russell really shows how easy it could be.

FredD