Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Cutting a blind opening for a door...

Posts

Cutting a blind opening for a door...

#1

Cutting a blind opening for a door...

Scott in Douglassville, PA

>Hi, all -

Not sure if my use of the word "blind" is appropriate, but I need to cut an opening for a door in a single piece of wood. The plans call for marking out, and cutting with a jigsaw. I can't cut a straight line with a jigsaw to save my life, so I'm looking for alternatives.

I'm thinking of roughing the opening with a jigsaw, then using a straightedge and a pattern bit in the router to clean the edges up. This seems like a lot of work, but I can't think of another way.

The panel is already sized and joinery finished, so I can't rip and crosscut the opening and reglue the panel.

Ideas?

Thanks,

Scott

Re: Cutting a blind opening for a door...

#2

Re: Cutting a blind opening for a door...

George@Colonel's Workshop-Havertown PA

>Good Afternoon Scott,

Using a router to flush up/straighten out the door opening should work well. All you need do is a little hand work on the corners.

George

Re: Cutting a blind opening for a door...

#3

Re: Cutting a blind opening for a door...

Fred Davis

>Clamp a straight edge to run against with your jigsaw, no corner cleanup that way

FredD

Re: Cutting a blind opening for a door...

#4

Re: Cutting a blind opening for a door...

Alexander Grigoriev

>Or use turner's (sticky) tape to stick the straightedge on, if the clampls can't be used.