Software Download *LINK*
Tony - Memphis
>I've written a couple of programs that I thought some other folks might could use. One calculates/prints cove profiles for cutting coves on the tablesaw. The other calculates/prints a volute/scroll like you would see on an ionic colum capital. Makes a handy template for laying out a volute for carving. Both are pretty simple to use. I'm not a programmer! So, keep that in mind. I'm also not fluent in distributing my programs. So far, these download and install fine on my equipment. Anyway, hope somebody can use these.
And of course I must add, cutting coves on the ts can be dangerous if not done with all the proper safety considerations...so be careful!
I have not verified the templates 100%, but what I have checked looked correct.
Tony
Well, I just noticed that the tab title is wrong for the volute page...I'll fix that later. Oh, and I rarely check the email that is posted on those pages. I forgot it was there!



