Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Need good 13/16 Fostner bit------WebKitFormBoundar

Posts

Need good 13/16 Fostner bit------WebKitFormBoundar

#1

Need good 13/16 Fostner bit------WebKitFormBoundar

Joe Pack------WebKitFormBoundary+jxYpItY7xRtMDYV

>I posted this on the turning forum also, but thought flat workers might have some good ideas too.

I am looking for a high quality 13/16 fostner bit for boring kaleidoscope blanks. I have one I got from Rockler, but it is dulling quickly, after only a dozen or so 2 1/4" deep holes in endgrain of exotics. I am drilling at 380 rpm, +/-, without extreme pressure, but I can already tell the bit is dulling. For boring just a couple, the bit I have would be okay, but I am looking at a couple of dozen in the next two weeks. (Partial gloat...I made just 6 for a craft show today to see if they would sell, and was pleasantly surprised to sell all 6 in the first 2 hours of the show, with the last lady asking if I had more!)

I don't mind paying a bit more for a bit that will last, even carbide if that is a good cost/benefit . What brand and source would you recommend?

------WebKitFormBoundary+jxYpItY7xRtMDYV

Re: Need good 13/16 Fostner bit------WebKitFormBoundar

#2

Re: Need good 13/16 Fostner bit------WebKitFormBou

Fred Davis

>High speed steel will not stand up to the heat end grain exotics would create.

Check with Nordic tools in Turlocl , CA,. they are past masters at this type of work.

Nordictools .com

FredD

Re: Need good 13/16 Fostner bit------WebKitFormBoundar

#3

Sharpen yours!

Lee Schierer - McKean, PA

>You can sharpen your bits by hand with a fine file or diamond hone. Do all the filing on the inside surfaces and you won't change the diameter. It only takes a couple of minutes to restore the edges to sharper than factory levels.

Lee