Bandsaw dust collection..
Norman (Ottawa, Ont.)
>I finally hunkered down and made the hole in the bottom door of my bandsaw today :) This has been nagging me for a long time and I kept telling myself I would go ahead and get this done someday. Dust collection on the Delta 14 in. bandsaws is mediocre at best, no matter how effective my jury-rigged dust collection was at below the blade area, fine dust would get spun around the bottom wheel and get ejected again at the top. This bandsaw is almost the only remaining source of dust in my current shop.
I used a bi-metal 4 inch hole saw and located the hole as close to the bottom of the door as possible. A short time later and some cutting oil, it was all done. Some filing and sanding to get the edges of the hole smooth and remove any flashing.
Installed an angled 4 in. flange with posi-lock nuts , washers and short machine screws, set up the hoses to join together in a Y, and tested it. No more fine dust blowing out the top! Only a little larger and heavier dust which remains at the bottom of the wheel housing is all now, a huge improvement.
I feel like I've slayed a dragon :)
Norman









