Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Floor Finish

Posts

Floor Finish

#1

Floor Finish

Brian in Cheyenne

>I have wide red oak t&g flooring which has already been stained and finished previously. The finish used was polyurethane, but after a few years, the finish is already beginning to show wear and tear. I'd like to refinish the top coat of poly.

Will a good sanding be all that is needed before putting down 3-4 coats of new poly? Should I use something other than poly? 9I would have considered tung oil derivitives, but with the poly already on there, I think this option has been eliminated.)

Any suggestions? Thanks!

Re: Floor Finish

#2

Re: Floor Finish

Chuck in ND

>You will first want to make sure there is no wax on the floor, after that sand it very lightly so you don't sand into any of the stain, 220 would probably be a good grit. Poly is what you should use, it's the most durable. If you can, find out if an oil base or water base was used and do the same. I prefer oil base, but I would use the same as what was used initially.

Re: Floor Finish

#3

Re: Floor Finish

ken raddon

>You will need to sand the floor to remove scratches. Too what degree depends on the severity of the scratches.

If you've never finished a floor then go to a store that sells to hardwood finish guys. Tell them you're an accomplished (go ahead and exagerate a little) wood worker and need to look at what tools they have for finsing a floor.

The tools for floors are very different than for furniture but you probably knew that.

BTW You can put water based poly over oil based poly but not vice versa.

Ken Raddon.

Re: Floor Finish

#4

Re: Floor Finish

Chuck in ND

>I don't need to exagerate, I refinished floors for a year, and I've been a woodworker for quite awhile.