What does it mean..."12 inch drill press"
Mike Jones, Redding, CA
>Exactly what does this measurement pertain to? Maximum vertical throw? Throat depth from centerline to support shaft? What?
Knowledge You Can Build On — Est. 1998
What does it mean..."12 inch drill press"
Mike Jones, Redding, CA
>Exactly what does this measurement pertain to? Maximum vertical throw? Throat depth from centerline to support shaft? What?
Re: What does it mean..."12 inch drill press"
Tom MacGregor
>A 12 inch drill press has the capacity to drill to the center of something 12 inches wide. That would mean there was 6 inches from the edge of the column to the center line of the chuck.
Re: What does it mean..."12 inch drill press"
John K Jordan
>If shopping for a drill press, be careful of the specs for how deep you can drill, which I think is called the "quill depth".
I have two machines - a benchtop and a similar floor model. The floor model has a longer quill depth - the benchtop model cannot even drill all the way through a pen blank in one operation.
JKJ