Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Mom-in-Law's footstool - Progress!

Posts

Mom-in-Law's footstool - Progress!

#1

Mom-in-Law's footstool - Progress!

Scott in Douglassville, PA

>Hi, all -

Well, after a bunch of putting off finishing turnings, turning down tenons, etc, I finally have made some progress on the MiL footstool project. Just as a review, MiL had knee surgery last week on her replaced knee, and is having the other replaced in about three weeks. I thought a turned Shaker stool to rest her feet on would help her recovery. And so, there ya go.

Anyway, turnings are done, tenons sized, and shellac padded on while still on the lathe:

Photobucket

I messed around with a rudimentary fence for my tabletop drill press, and started boring mortises. Six down, eighteen to go...

Photobucket

So far, so good. Everything lines up, tenons are snug, and the first panel's done! Woot! I still need to part off the top of the legs, but will worry 'bout that when I'm close to gluing.

Thanks for looking. More pics forthcoming...

Scott

Re: Mom-in-Law's footstool - Progress!

#2

Re: Mom-in-Law's footstool - Progress!

Don Orr

>That looks great ! Is that curly cherry ? Sweet ! Looking forwar to the finished stool. Best of luck to the MIL.

Re: Mom-in-Law's footstool - Progress!

#3

Re: Mom-in-Law's footstool - Progress!

Bill White

>Foot stool looks like a winner. Any chance on further info about

padding the shellac? I have not done it yet, and would like a tutorial.

Bill

Re: Mom-in-Law's footstool - Progress!

#4

Curly...

Scott in Douglassville, PA

>Hi, Don -

Yeah, majority of the wood's curly cherry. Should look nice as the wood darkens. There's a bit of flatsawn wood in it, too, but even that has some figure to it...

Scott

Re: Mom-in-Law's footstool - Progress!

#5

Padding...

Scott in Douglassville, PA

>Bill, I've only had success with shellac on this stool. Ever. FWIW, I prepped the wood by sanding it with 150 through 600 sandpaper, then burnished it with 0000 steel woold and shavings from the lathe. I then used an old cloth, folded on itself into a little pad, dipped it into straight SealCoat to saturate it, then, with the lathe cranked up to it's max speed, gently ran the pad across the spinning work. I tried to use a light touch - as the finish builds, friction will heat up the shellac and dull it (at least, that's how it seemed to me). I added about a dozen coats of shellac this way to each piece. Spinning on the lathe, the shellac dried pretty quickly. Nicest finish I've ever gotten on anything.

Hope this helps a little.

Scott

Re: Mom-in-Law's footstool - Progress!

#6

Scott That Looks Wonderful

George@Colonel's Workshop-Havertown PA

>

Re: Mom-in-Law's footstool - Progress!

#7

Half done...

Scott in Douglassville, PA

>Half the mortises bored. Will part off the tops of the posts, touch up the shellac where needed, and glue up the side ladders tonight, baby!

(BTW, the near side tenons aren't fully seated on either ladder yet. Once they're in, they're not going to come out, so they're only half seated for now...)

Scott


img