Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

breadboard ends

Posts

breadboard ends

#1

breadboard ends

Erick Singleman

>Okay, I put the last coat of finish on my dining table. After sanding and polishing, I will have approximately 4 coats of poly on the top and bottom.

Here's the question: My breadboard ends are flush to the table top meaning ther is no microbevel or other such rounding between them to act as a separator. That said, should I make a cut with and exacto knife or other blade to slice through the finish at this interface? As we all know the table will move due to moisture changes, and I am thinking that the finish that passes over this joint could get pulled and maybe fracture in an unfavorable way.

Re: breadboard ends

#2

Re: breadboard ends

Fred Davis

>Erik,

That is a good question and one you may have wanted to consider before the finish went on.

If the finish fractures and that is problematic ,considering the varying conditions that may occour, for instance,if the final resting place of the table has a relative humidity similar to that of the shop where it was built ,there could be very little movement, even none.

But that happening is rare, since you have two different grain directions opposing , then some movement is hard to avoid.

That being said , I think from looking at this type of crack in the finish, if it happens , it will follow the line of least resistence and fracture along the joint , which I think is a more normal lookingand nicer to the touch then a knife cut.

But again , that is just what I think.

FredD

Re: breadboard ends

#3

Re: breadboard ends

Tony-Memphis

>I built a breaffast room table out of cherry several years ago. I used a wipe on poly (several coats). I did nothing to the breadboard end "joints" and it has never been a problem. Unless your coats are very thick, I wouldn't think it would be a problem. Mine moved immediately upon delivery to the breakfast room from the shop. The shop is heated and cooled, so I assumed the humidity would be similar, but it wasn't!

Tony

Re: breadboard ends

#4

Re: breadboard ends

John Veerkamp, Western Mo

>Even with wood that moves a lot like spruce and fir I've never had a problem with the finish at the breadboard edges. I agree that a knife cut will be quite noticeable. Leave it alnoe and you'll be fine.

John

Re: breadboard ends

#5

Re: breadboard ends

Pete LaBelle

>Something to think about:

If the wood was fully dry, dry shop, dry time of the year, pretty much all the wood could do is grow when the humidity starts to climb. Wood expanding into a varnished up joint will probably not do as much harm.

If the wood was not dry yet, the shop damp, and going into a dry house, the wood is going to shrink yet, and would be more apt to tear itself (split) if the joint was varnished shut. Not sure if it would happen, but something to consider.