Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Veneering

Posts

Veneering

#1

Veneering

mdclor

>Good morning to all,

I have never done any veneering, but think I need to for my next project. I will build a mantel shelf from QSWO and would like it to appear to be a solid piece 4 inches thick, but with the rays showing on the top, bottom and front. I don't have any stoch this thick and I think the weight would be a problem. I plan to use a french cleat to attach it to the wall. I remember seeing a post in the last few months where one of the WC resident masters veneered end grain to a substrate to make a piece, but I can't find it searching the current messages or the archives. Any guidance will be greatly appreciated. If I do this, will I need to veneer the inside as well?

TIA,

Merle

Re: Veneering

#2

Re: Veneering

John K Jordan

>I think you shouldn't display the QS on the front, just the top and bottom, or it may spoil the illusion and look like a box covered by veneer rather than a slab. I'd think you might use some creative design to hide the missing endgrain of the "slab".

A couple of years ago I built steps for the front of my house from 4" thick white oak slabs I cut with my sawmill. This makes me think that if you have a small local sawmill that does custom work, you might get them to cut some thin QS boards from a log which would show the QS figure and cut another board flatsawn from the same log for the front, dry and plane, then assemble into a box.

JKJ

Re: Veneering

#3

Re: Veneering

mdclor

>John,

Thanks for the response and I see your point. Unfortunately, there isn't too much white oak in the Albuquerque, NM area, nor have I seen any saw mills. I may have to come up with another idea for this anyhow because I haven't been able to figure out how I would get all the end grain from separate boards to align properly.

Merle