Re: glueing over poly
Jim Dillon
>Denny,
Usually, I interpret "...finish before glueing..." as meaning that the areas where glue will be used are devoid of finish - thus giving a much better bond. As mentioned, tape is used and must be pressed down really well to minimize seep of finish under the tape. Some seepage probably will occur, but, hopefully, enough unfinished wood will be left to give you a good bond. This is kinda a trade-off decision. In some cases, the decision is somewhat clear like panels in doors, complicated and hard to reach places etc.. But in other cases, the labor of taping everything off may not be worth the effort of just biting the bullet and spending a LOT of time applying the finish to the assembled workpiece and then (in some instances) a LOT of time wiping if off. I guess I try to examine the preassembled workpiece and try to imagine how difficult it would be to apply finish (using hand, brush, wipe, or spray) to all areas of the workpiece. That will dictate to me if I need to tape joints or not. Personally, I have done far more prefinishing of door/carcass panels etc. than any taping of joints. Any taping that I have done is actually to catch any glue squeeze-out - especially on the inside of boxes.
Jim